The set of hemiviers, The set of hemmers – SINGER W431 User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THE SET OF HEMIVIERS
Before attaching any of the hemmers, be sure bobbin thread is pulled up.
Then, with hemmer in place, hold top thread loosely
and
turn
handwheel
one-
full
turn
toward
you,
making
a
loop
under
hemmer. Grasp bobbin thread with both hands and slip horizontally under hemmer
toward back. Bobbin thread will catch loop and carry upper thread to back of
hemmer.
Fold material to suit for two inches along edge, hold at each end of fold. Slip fold
into guide and up.over spoon. Fold hem in material back of hemmer. Draw forward
to end of hem and fasten with point of needle. Pull on threads gently as you start
stitching.
\ '• «V«*« V • V-• • •' V
You can tnake a hem 1/4", 3/8", 5/8" or 7/8" .in width, depending upon which
hemmer you use. A few uses are shown below.
45