SINGER 147-60 - Manual (Page 2)

INSTRUCTIONS FOR OILING
To ensure easy running and prevent unnecessary wear of
the parts which are in movable contact, the machine requires
oiling and when in continuous use, "TYPE B" or "TYPE D" OIL,
sold by Singer Sewing Machine Company, should be
applied ot least twice each day to all oil holes marked
"OIL".
"TYPE D” OIL should be used when an oil is desired
which will produce a minimum of stain on fabrics, even
after a long period of storage.
The letter "o”, marked on oil pipe couplings must always
be at the top. This is to insure that the oil spoon, attached to the
inner end of each coupling, is open side up to receive the oil.
Copyright, U. S. A„ 1 925, 1931 and 1932,
by The Singer Monufacturing Company
All Rights Reserved for all Countries
INDEX
PAGE
A ccessouies ........................................................................................... 37
B elt G uahd ............................................................................................ 37
B ench S tand .......................................................................................... 37
F ittings f o k 147-60 M achine (L ap S eam F eller N o .
120906).......................................................................................... 35
F ittings f o r 147-61 M achine (L ap S eam F eller N o .
120848).......................................................................................... 36
F oot L ifter P arts ................................................................................. 33
K nee L ifter P arts ................................................................................. 33
L ap S eam F ellers .................................................................................. 37
M achine N o . 147-60....................................................................................................... 7
" “ 147-61............................................................................................ 21
B ase ..................................................................................... 39
N umerical L ist op P arts ..................................................................... 41
T hread U nwinder ................................................................................. 39