Maytag ACCELLIS MER67 - Manual (Page 11)

CONTROL OPTIONS
12 H our O ff (4)
To Change Factory Set Control Options:
1. Press the Setup Options (0) pad and
the desired option pad. (See Options
below.)
2. Current option will appear in the dis­
play.
3. Press the AUTO SET pad to change
the option.
4. Press any key other than CANCEL to
enter changes.
The oven may be set to turn off after 12
hours or stay on indefinitely. The default
is set to turn the oven off after 12 hours.
3. Press the AUTO SET pad - each
press changes the temperature by 5°
F. The control will accept changes
from -35° F to +35° F.
S croll S peed (5)
The scroll speed of the messages in the
display may be changed from FAST to
MEDIUM to SLOW. The default is set for
the medium speed.
4. If the oven was previously adjusted,
the change will be displayed, For
example, if the oven temperature was
reduced by 15° F, the display will
show-15° F.
OPTIONS AVAILABLE:
C ontrol L ock (1)
D isplay D im (6)
The control intensity may be changed
for easier reading. The default is set for
the highest intensity «*“***. The fewer *****
the less the intensity.
5. When you have made the adjustment,
press any key other than CANCEL
and the time of day will reappear in the
display. The oven will now bake at the
adjusted temperature.
The function pads on the control can be
locked to prevent unwanted use for
safety and cleaning benefits. The cur­
rent time of day will remain in the display.
T emp C/F(7)
OYfN RACKS
The temperature scale may be changed
to Centigrade or Fahrenheit. The default
is set for Fahrenheit.
The range is equipped with two oven
racks. One rack is “straight", the other
rack has an “upturned” front edge.
T imer B eeps (2)
There are three choices for the end of
"timer" reminder signals.
>• Four beeps followed by two beeps ev­
ery 30 seconds for up to five minutes,
(default setting)
Four beeps followed by two beeps ev­
ery 60 seconds for up to 60 minutes.
> Four beeps followed by no other beeps.
L anguage (8)
The words which scroil in the display
may be changed from English to French
or Spanish.
If baking on the lowest rack position, use
the upturned rack in that position. The
front edge of the upturned rack can be
used as a “handle” when pulling the rack
out of the oven to check or remove food.
D efault (9)
The control can be reset to restore the
factory setting for each option.
D isplay O n /O ff (C lock )
C ook T ime B eeps (3)
There are three choices for the end of
"clockcontrolled cooking" reminder sig­
nals.
The time-of-day display/clock may be
shut off when the oven Is not in a cook­
ing or cleaning function.
All racks are designed with a lock-stop
edge.
To remove oven racks:
O ven T emperature A djustment
Three short beeps followed by two
beeps every minute for up to 30 min­
utes. (default setting)
■Three short beeps followed by no othe r
beeps.
' Three short beeps followed by two
beeps every 30 seconds for up to 5
minutes.
If you think the oven is operating too cold or
hot, you can adjust it. Bake several test
items and then adjust the temperature set­
ting not more than 10° F at a time.
> Pull rack straight out until it stops at
the lock-stop position; lift up on the
front of the rack and pull out.
To Adjust:
1. Press the BAKE pad and enter 550° F,
2. Press and hold the BAKE pad for sev­
eral seconds until TEMP ADJ is dis­
played.
To replace oven racks:
Place rack on the rack support in the
oven; tilt the front end up slightly; slide
rack back until it clears the lock-stop
position; lower front and slide back
into the oven.