SINGER WK-100 - Manual (Page 22)

22. BLIND HEMMING
1. Set zigzag indicator on # 4.
2. Set stitch length on largest stitch lo­
cated on stitch length indicator plate.
3. Fold the material as shown in Fig. 57-
A.
4. Turn the fly wheel toward you by
hand until the needle is on the left
side of the zigzag. Place the material
under the presser foot, then adjust the
material until the left side of the fold
is directly under the needle.
5. Make the first stitch by running the
needle through the material by hand,
being very careful to Just barely catch
the folded edge. (See Fig. 57-B) These
stitches should be on the reverse side
of your material. When you open the
folded material, the blind stitch will
be on the front side of your material.
(See. Fig. 57-C)
CAUTION : When making blind hem,
run the machine very slowly. For best
results loosen upper thread tension.
23. UPPtlQUEING
1. Adjust the machine to a narrow zig
zag stitch.
2. Set the stitch length to smallest stitch.
Baste material on to the article, then
sew around the edges of the material.
Fig. 57
Fig. 58
21