SINGER 214 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
21
1. Insert the two pins on the feed cover plate
into the two holes on the fabric feed area.
The curved corners will be toward you
when it is in place>
2, a. Set zigzag width at 0.
b. Place the button on the fabric with two
holes centrally situated ur^der the slot In
the presser foot.
a. Pierce the fabric through the hole on the
right side of the button*
b,
lower the presser foot.
4. a. Turn the hand wheel toward you until
the needle is just above the button*
b* Adjust the stitch width control so that
the needle enters the left hole of the
button.
5. Set the speed range at LOW position and
make six or more stitches ending on the
right side*
6. a. Set the zigzag width at 0*
b. Take about three stitches for fastening
off.