Operating instructions, Select water level, Select wash/rinse water temperature – Maytag LAT8714 User Manual
Page 4: Select water temperature
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATING INSTRUCTIONS
twtttfre WATCH levEL
iiWASH
•
RMS
£
TCMPEFtATURE
iHHŒiM;
o
Q
mait
AG f;p»'\wsi.ew«f pk! |®iÌÌÈ||i^SiÌiB^ISÌ|p
Select Water Level
Turn the selector knob to the setting that matches
the size of the load.
The pre-set selector knob (not on all models) can
be set to five distinct settings - EX. SMALL,
SMALL, MEDIUM, LARGE or EX. LARGE.
The infinite selector knob (not on all models) can
be moved to each water level or any point in
between.
If more water is needed once the fill is complete,
move the knob to Reset, then to the desired
setting.
For best washing results, clothes must circulate
freely. If too little water is used, poor cleaning,
linting and excessive wear may result. Use the
following as a guide to select the proper water
level:
Ex. Small - 1/4 full of clothes.
Small - 1 /4 to 1 /3 full of clothes.
Medium - 1 /3 to 1 /2 full of clothes.
Large - 1 /2 to 3/4 full of clothes.
Ex, Large - 3/4 to full of clothes,
NOTE:
When laundering permanent press items
or items of delicate construction,
washable woolens or loosely knit items,
never use less than the MEDIUM setting.
This will minimize shrinkage, wrinkling
and pulling of seams.
(Features may vary c
Select Wash/Rinse Water
Temperature
Turn the selector knob to the water temperature
desired.
HOT/COLD - Wash water will be the
temperature of the water coming from the hot
water faucet. Rinse water will be cold. Use this
setting for heavily soiled whites and colorfast
items.
WARM/WARM - Wash water will be a mixture
of water coming from the hot and cold water
faucets. Rinse water will be the same, except
when the permanent press cycle is selected; then
it will automatically be cold. Use this setting for
délicates and for colored items when a warm
rinse following the wash is preferred.
WARM/COLD - Wash water will be a mixture of
water coming from the hot and cold water
faucets. Rinse water will be cold. Use this for
items with moderate soil level and colored items.
COLD/COLD - Wash and rinse water will be the
temperature of the water coming from the cold
water faucet. Use this setting to minimize fading
of brightly colored items and shrinkage of
washable woolens.
NOTEi
Water below 65°F is
too cold to dissolve and activate granular laundry
detergents.
PAGE 4