Button sewing foot, Thread shank – SINGER 431 User Manual

Page 54

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BUTTON SEWING FOOT

Set Lever at 4. The needle should then enter into

the right hole of the button. Take approximately
six zigzag stitches in this position. End at the left
side.

To fasten stitching, adjust to number 1 Stitch

Width setting and take approximately three stitches.

THREAD SHANK

In order to form a shank, stitching is worked

over a regular machine needle. Position button and

lower button foot. Place needle in the groove of
the .foot so t];ie point enters the hole.

A larger shank results when the heavy end of

the needle is utilized.