SINGER W815 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
20. BUTTON SEWING
Turn balance wheel towards you to get needle to .ts highest pos.tion.
Raise presser bar and replace regular presser foot, with button sewing
‘oot as shown in Fig. 23- Drop the feed dog as required for darning
and embro.denng. Upper and lower thread tensions remain the same
as for ordinary sewing.
Place material or garment together with button under the presser
foot so that holes in button line up with oblong hole in presser foot.
.Adiust width of zigzag stitch to permit needle to pass through center
of holes
In
button.
■ u •
K
r
rh, balance wheel by hand towards you to make sure that needle will stitch in
Before sewing with power, turn the balance wneei uy a
the center of the holes m button.lf the needle hit the button it will break.
Then sew five to six stitches to attach button.
When attaching four-hole buttons first sew one set of two holes, then stitch into second set of two holes an
lock thread with two or three plain stitches in last hole.
Fig 23
1 8 -