Binder, Folded binding (fig. 69), Two-tone binding (fig c) – SINGER W714 User Manual

Page 38: Hand-cut bias binding (fig. 69)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

B I N D E R

SlotFin

5“® binding and applies it to the edge of material in one operation,

blots on scroll of the binder are for corresponding widths of commercially folded bias binding

The open mouth of binder scroll is used for unfolded bias strips cut 15/16 inch wide

FOLDED BINDING

(Fig. 69)

Cut a point on folded binding, insert in appropriate

slot. Draw through slot and under binder with strong

pin. Test stitching to be sure it is on the edge. Adjust
by sliding binder to right or left.

TWO-TONE

BINDING

(Fig..

Two bindings can be sewn on fabric edge also in one

operation. When two are used, always skip one size be
tween widths, inserting each in correct size slot.

HAND-CUT BIAS BINDING

(Fig.

69)

Cut 15/16 inch bias binding fold in half for a couple

of inches. Cut binding diagonally toward end, almost to

fold. Slip fold into center of binder. Draw back until
cut opens and binding encircles open end of scroll. Test
stitching to be sure it is on the edge, adjust if necessary.

See Figs. 67

and

for

suggestions
on how to use
the binder.

There

are

hundreds

other uses.

Fig. 69

Fig. 68

Fig. 70