Removing bobbin case, Replacing bobbin case, Replacing slide plate – SINGER 2112 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing Bobbin Case
* Remove needle and needle plate.
^ Open slide plate and lift out bobbin.
^ Using small screwdriveri turn bobbin case
retainer (1) in direction of arrow (2) as far as it
will go.
* Lift out bobbin case (3).
Using soft brush, brush lint from case and other
mechanical parts in the bobbin area.
Replacing Bobbin Case
^ Insert case with a back and forth motion
so front of case lies under position plate (4).
^ With small screwdriver, turn bobbin case
retainer in direction of arrow (5) to lock case
in place.
^ Reinsert needle, needle plate, and bobbin and
close slide plate.
Replacing Slide Plate
Should slide plate become detached, replace as
follows:
^ Place slide plate in slide way with the front
edge close to, but not covering, the retaining
spring (6).
^ With a screwdriver, lift each end of spring
into the side grooves on the underside of the
plate.
^ Draw plate gently towards you to engage
spring. Then, close plate.
30