Changing needles, Removing needleplate, Replacing needleplate – SINGER 2112 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing Needles
* Raise needle to highest position by turning
handwheel towards the operator.
^ Loosen needle clamp screw (1) and remove
needle.
* With flat side of needle to the back, insert new
needle into clamp (2) as far as it will go.
5k Tighten needle clamp screw (1) securely.
Check the Fabric, Thread and Needle Chart in
this book for correct needle and fabric
combinations.
Removing Needleplate
For either cleaning or use of the straight
stitch plate, available from an approved
dealer, do the following:
5k Raise needle and presser foot to their
highest positions.
5k Open slide plate and place thumb under right
side of needle plate (3).
5k Lift up and pull plate to the right to
remove it from the machine.
Replacing Needleplate
5k Holding needle plate as shown, slide it to the
left under the head of clamping pin (4).
5k Press down on right side at (3) until it fits se
curely in place.