SINGER 9224 User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CLEANING MACHIN
Using lint brush, remove lint or
dust from:
-presser bar
-needle bar
-machine surface (if necessary,
dampen a soft cloth and use a
mild soap to clean the surface)
Remove
needle
plate
as
instructed
and
clean
exposed
area with lint brush.
-bobbin case (if there is a lot of
lint in this area, remove bobbin
case for cleaning)
PROBLEM
CAUSE
Needle does not move
Is machine connected to electrical supply?
Is power and light switch on?
Is controller connected?
Is air supply from controller clear?
Needle moves but stitch
is not formed
Is needle defective?
Is needle fully inserted-into needle clamp?
Are bobbin and needle correctly threaded?
Is bobbin correctly inserted into bobbin case?
Needle breaks
Is needle straight and sharp?
Is needle correct size?
Is needle fully inserted Into needle clamp?
Are controls properly set?
Are accessories correct for application?
Bobbin winding
difficulties
Is thread unwinding freely from spool?
Is slide plate In proper position?
Is thread end securely held at start of wind?
Upper thread breaks
Is machine properly threaded?
Is thread freely unwinding from spool?
Is proper size spool cap being used?
Is needle correct size for thread?
Is upper thread tension too tight?
Is bobbin case properly inserted?
Is bobbin rim free of nicks?
Lower thread breaks
Is bobbin correctly wound?
Is bobbin correctly inserted in bobbin case?
Is bobbin case correctly threaded?
Skipped stitches
Is machine properly threaded?
Is fabric firmly held down?
Is needle correct style and size?
Is needle straight and sharp?
Fabric does not move
properly under presser
foot
Is presser foot correctly attached to machine?
Is presser foot lowered?
Is stitch length correctly set?
FOR BEST PERFORMANCE, PURCHASE ONLY GENUINE SINGER
ACCESSORIES AND REPLACEMENT PARTS.
-
24
-