SINGER 9224 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING AND REPLACING BOBBIN CASE
REMOVING AND REPLACING LIGHT BULB
mma
Open slide plate and remove
bobbin.
Lift needle plate (1) by right
corner.
Push lever (2) towards you until
it
stops,
and
hold
in
this
position.
Lift bobbin case up and guide it
out toward you, as shown.
Push lever (2) towards you.
Guide bobbin case into place,
making sure block (3) is under
metal bracket (4).
Return
lever
(2)
to
locking
position over top of bobbin case.
To replace needle plate, slide it
under pin (5) and push it to the
left.
y
Loosen screw and face plate.
(Screwdriver not included)
TO REMOVE
Pull down light reflector (1).
Pull bulb down.
TO REPLACE
Push
new
bulb
into
light
socket (2).
(Use only a 5 watts 12 volts
light bulb part #979603)
Push light reflector (1) into
place.
Make sure the small end of
light reflector is aligned with
the small end of light socket
(
2
).
-
23
-