Kodak EASYSHARE C 503 - Manual (Page 43)

Troubleshooting
If... Try one or more of the following
Ready light glows
steady red.
■ Transfer pictures to the computer (page 12), delete pictures from the
camera (page 10), switch image storage locations (page 23), or insert
a card with available memory (page 3).
■ Wait. Resume picture taking when the light turns green.
Change the image storage location to internal memory (page 23), or
use a different card.
Ready light glows
steady green.
■ Camera is operating normally.
Camera/computer communications
If.. Try one or more of the following
Thecomputerdoes
not communicate
with the camera.
■ Visit www.kodak.com/go/c533support or
www.kodak.com/go/c503support.
■ Turn on the camera (page 2).
■ Install new batteries (page 1) or charge rechargeable batteries.
■ See the Power Management section of the laptop user's guide to
disable this feature.
■ Connect cable to camera and computer port (page 12).
■ Install the software (page 11).
Disconnect the USB cable. Close all open applications. Re-install the
software (page 11).
■ Disconnect camera from the computer. Close all software applications,
reconnect camera.
Cannot transfer
pictures.
(The Add New
Hardware Wizard
cannot locate
drivers.)
Disconnect USB cable. (If using camera dock or printer dock,
disconnect cable and remove camera from dock). Close all open
applications. Re-install the software (page 11).
Disconnect the USB cable. Close all open applications. Re-install the
software (page 11).
38 di) WWW. kodak, com/go/support