Tascam DA-88 - Manual (Page 22)

Autolocation Controls
□ Setting Locating Points
MEMO 1
□
DISPLAY
□
T A
□ □
T A
□ □
LOG 1
□
□ Repeat Play
MEMO]
Outside the
repeat loop
MEMO 2
---- ►
Repeat segment
Outside the
repeat loop
vt/
—A- repeat
/0
□ □ □
22
Two locating points (MEMO 1 and MEMO 2) can be established on a given tape.
To set MEMO points :
Press MEMO (1 or 2) at the desired point during Play, or during Stop if the tape is
at the point you want to specify as a locating point.
To check MEMO points ;
Press the DiSPLAY switch (when the tape stops or is running) until the MEMO 1
(or 2) LED lights. The display is now showing the location stored into the
corresponding register.
To fine tune MEMO points :
When the MEMO point you want to fine tune is showing in the display, press A
to increment the numbers shown, or press ▼ to decrement them.
To speed up the tuning, you can hold down either A or T and press DISPLAY.
Each time you press DISPLAY, the next upper (left) two digits will fast
increment.
To clear MEMO points :
Hold either A or T and press the other. The locating point currently shown in the
display is erased from memory, as confirmed by "00:00:00:00" appearing instead.
To autolocate the tape to MEMO points :
Press LOG 1 to locate the tape to the MEMO 1 point. Press LOG 2 to locate the
tape to the MEMO 2 point.
At the end of locating functions the tape will stop unless AUTO PLAY is
previously pressed.
ICF The LOC keys cannot operate during rewind, punch-in/out process, or when
two or more DA-88s are hooked up and the slaves are chasing the master.
Pressing REPEAT lets the tape play between MEMO 1 and MEMO 2 points over
and over.
The MEMO 1 point should not be lower than the MEMO 2 point. The DA-88
understands the lower MEMO point as the start point of loop, and the higher
point, as the end.
To interrupt momentarily repeat play, press STOP. Press PLAY to resume play.
To exit repeat mode, press REPEAT.
o If only either MEMO 1 or MEMO 2 point is established, the tape will repeat
between that MEMO point and the counter zero point.