beautypg.com

To remove lawn mower from carton, Howto set up your lawn mower, To unfold handle (see fig. 1) – Sears 917.38614 User Manual

Page 6: To install attachments (see fig. 2), Asseivibly

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

m

¡an^ ¡¡mm m m

sr

%

s

^

ASSEIVIBLY

Read these instructions and this manual in its entirety
before you attempt to assemble or operate your new lawn
mower. Your new lawn mower has been assembled at the
factory with the exception of those parts left unassembled
for shipping purposes. All parts such as nuts, washers,
bolts, etc., necessary to complete the assembly have been
placed in the parts bag. To ensure safe and proper
operation of your lawn mower, all parts and hardware you

assemble must be tightened securely. Use the correct
tools as necessary to ensure proper tightness.

TO REMOVE LAWN MOWER FROM
CARTON

Remove loose parts included with mower.

• Cut down two end corners of carton and lay end panel

down flat.

Remove all packing materials except padding between
upper and lower handle and padding holding operator
presence control bar to upper handle.

Roll lawn mower out of carton and check carton thor­

oughly for additional loose parts.

HOWTO SET UP YOUR LAWN MOWER

TO UNFOLD HANDLE (See Fig. 1)

IMPORTANT; UNFOLD HANDLES CAREFULLY SO AS

NOT TO PINCH OR DAMAOE CONTROL CABLES.

Raise handies until lower handle section locks into

place in mowing position.

Raise upper handle section into place on lower handle,

remove protective padding and tighten both handle
knobs

Remove handle padding holding operator presence

control bar to upper handle.

» Your lawn mower handle can be adjusted for your

mowing comfort. Refer to "Adjust Handle" in the
Service and Adjustment section of this manual.

TO INSTALL ATTACHMENTS
(See Fig. 2)

Your lawn mower was shipped ready to be used as a
mulcher. To convert to bagging or discharging;

Open rear door and remove muicher plug. Store

mulcher plug in a safe place,

• You can now install catcher or optional clipping deflec­

tor.

To return to mulching operation, install mulcher plug

into discharge opening of mower.

A

CAUTION: Do not run your lawn mower
without mulcher plug in place or ap­
proved

clipping

deflector

or

grass

catcher in place. Never attempt to op­
erate the lawn mower with the rear door

removed or propped open.