To adjust attachment lift spring (see fig. 32), To remove hood and grill assembly (see fig. 33), Service and adjustments – Sears 917.25051 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
TO ADJUST ATTACHMENT LIFT SPRING
(See Fig. 32)
« While holding spring bushing with wrench, loosen jam
nut.
*
Turn adjustment boit clockwise to extend spring and
reduce lift effort (for heavier attachments).
*
Turn adjustment boit counterclockwise for lighter at
tachments.
'
» Retighten jam nut against spring bushing.
IMPORTANT:
DO NOT ADJUST FOR MAXIMUM SPRING
TENSION WHEN USING LIGHT ATTACHMENTS SUCH
AS A MOWER, ADJUST LIFT LEVER SPRING TO AID IN
LIFTING ATTACHMENT. DO NOT OVERPOWER SPR! NG.
WHEN REMOVING ATTACHMENT, ALWAYS ADJUST
SPRING TENSION TO ITS LOWEST POSITION.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 33)
® Raise hood.
•
Unsnap headlight wire connector.
•
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
•
To replace, reverse above procedure.
25