Sears 52268 - Manual (Page 13)

7. If tape holds bottom drawer cover to drawer supports,
remove the tape. Pull drawer partway out. Reach in, push
the rear of the glass up and, at the same time, back, until
it clears front-corner retainers,,
8. Tilt and remove the cover.
9. Tilt and remove the drawer.
After cleaning, replace drawers and covers in reverse
order. Reinstall the gasket at the rear of the top drawer.
Fit the end of the plastic drawer support into the slot on
the gasket, with the rubber
gasket flap facing you, Make
sure the gasket snaps into
place
Then replace the light panel
by hanging top of panel on
upper pins and pushing in at
bottom,
Drain Opening in Freezer Compartment
When cleaning, remove the
freezer bin and flush a
solution of baking soda (one
teaspoon) and two cups of
hot (not boiling) water
through the drain line with the
help of a meat bester. This
will help eliminate odor and
reduce the likelihood of a
clogged drain line.
If drain becomes clogged, use a meat basier and baking-
soda-and-water solution to force the clog through the
drain line.
Condenser
The condenser is located
behind the bose grille,. For
most efficient operation,
remove the base grille (see
page 3) and sweep away or
vacuum up dust that is readily
accessible. For best results,
use a brush specially
designed for this purpose.
It is available at your Sears store or service center. This
easy cleaning operation should be done at least once a
year.
Behind Refrigerator
Take care moving your refrigerator away from the wall.
All types of floor coverings can be damaged, particularly
cushioned coverings and those with embossed surfaces
Pull the refrigerator straight out and return it to position by
pushing If straight in.. Moving refrigerator in a side
direction may damage floor covering or refrigerator.
Light Bulb Replacement
Unplug refrigerator before changing a fight bulb.
Fresh Food Compartment Interior
1. To align the control knob
properly, note position of
numbered control for proper
reassembly and pull off
knob.
2. Pull bottom of light panel
down about 1 /4-inch“iu5f
enough to disengage lip at
rear from grooves in retainers on rear wall.
3. Lift panel to disengage top from pins on side walls and
remove panel.
After replacing with same size bulb, reinstall panel (hang
top on pins; pull bottom down, push it back and release it
to let lip engage grooves in retainers) Replace
temperature control knob in OFF position, turn it to
previous setting, and plug refrigerator back in.
Freezer Compartment
1. Remove shelf just
below light panel, (Shelf
will be easier to remove
if it is emptied first.)
2. Pull plastic light panel
toward you, (It will bend to
free tabs from grooves )
3. After replacing with same size bulb, reinstall panel
and shelf
13