Sears 247.797851 - Manual (Page 6)

Spacers
(inside
iHinge) Hex Bolt
4" Long
Chute
Deflector
Hand
Knob
HOW TO SET-UP YOUR CHIPPER-SHREDDER
A
MAKE CERTAIN THE SPARK PLUG WIRE
IS DISCONNECTED AND MOVED AWAY
FROM THE SPARK PLUG BEFORE AS­
SEMBLING THE CHIPPER-SHREDDER.
FIGURE 3.
Hopper Pivot
Doorv
Assemble This
Truss Screw and
Nut
Release
Bar
FIGURE 4
\
Upper
Guide
Assembly
Washer
Nut
Hopr^r Assembly
Truss Screws
and Nuts
Upper
Guide
Extension
Remove Truss
Upper Screw and Nut
Guide
Assembly
Plunger
FIGURE 5.
ATTACHING THE CHUTE DEFLECTOR
• Place one flat washer 1/4" I.D., then one spacer 1/4"
I.D. on hex bolt 4" long.
• Place chute deflector in position on the discharge
opening, on the left side of the chipper-shredder.
• Insert hex bolt through hinge on chute deflector and
----- housing (spacer fits inside of hinge). See figure 2.
• Place second spacer 1/4" I.D. over hex bolt, inside
other part of hinge. Secure with 1 /4" I.D. flat washer,
lock washer and hex nut. Tighten securely.
• Secure both sides of chute deflector to housing us­
ing hand knobs and cupped washers 5/16" I.D.
(cupped side of washers go against chute deflector).
ATTACHING THE UPPER GUIDE ASSEMBLY
Place upper guide assembly in position on frame, mak­
ing certain edges of the upper guide assembly are
underneath stop washers, and the release bar is in the
-slots. See figure 3. Insert hex bolt 8-3/8" long through
upper guide assembly and frame. Secure with flat
washer 5/16" I.D. and hex lock nut.
NOTE: Make certain upper guide assembly can pivot
by pulling up on release bar and lowering upper guide
assembly. If necessary, loosen hex lock nut a turn or
two. Put the upper guide assembly back into the raised
position.
ATTACHING THE HOPPER ASSEMBLY
Your chipper-shredder has been shipped with the upper
guide extension attached to the hopper assembly. See
-figure 4. Attach the hopper assembly to the upper guide
assembly as follows. Be certain to place heads of all
truss machine screws
inside of hopper assembly.
• Remove one truss machine screw and nut from each
side of hopper assembly as shown in figure 4. Push
hopper pivot door down inside lower part of hop­
per as you place hopper assembly (both pieces) in­
side upper guide assembly. Replace truss screws
and nuts just removed, using the front upper hole
in assembly as shown in figure 4, one on each side.
Tighten finger tight only.
• Place the six truss machine screws and nuts found
in hardware pack in the remaining holes of hopper
assembly, alternating sides of the unit and tighten­
ing finger tight only.
• After assembling all eight screws, tighten them
securely.
ATTACHING THE CATCHER BAG
-Your chipper-shredder is equipped with a catcher bag
to catch the shredded material.