Sears 944.528117 - Manual (Page 10)

OPERATION
GASOLINE
FILLER CAP
MUFFLER
CHOKE
CON­
TROL
PRIMER
SAFETY
IGNITION
KEY
AUGER DRIVE DISCHARGE DEFLECTOR
ELECTRIC CONTROL SPEED CHUTE REMOTE
START BUTTON LEVER CONTROL CONTROL
LEVER LEVER
CONTROL
LEVER
TRACTION
DRIVE
CONTROL
LEVER
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY
VARY WITH THE
ENGINE ON YOUR
UNIT.
LIGHT
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
AUGERS
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and
wrench.
Safety Ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the
engine.
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
10
ON / OFF switch - used to STOP the engine.
Choke control - used for starting a cold engine.
Traction drive control lever - used to engage power-
propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Deflector remote control lever - used to change the di­
stance the snow is thrown.
Discharge chute control lever - used to change the direc­
tion the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.