Sears 625.34855 - Manual (Page 6)

SECTION 1
WATER SOFTENER START-UP
1C. PROGRAM THE TIMER
FIG.1
low salt
indicator
ON/OFF-HOLD #i SELECT
button button UP button DOWN button
on/off button button
When the transformer is plugged in, the model
code AR31, and a test number (example: ALO)
show in the face plate display for 4 seconds.
Then, 12:00 AM and PRESENT TIME begin to
flash.
repeatedly when the display reaches 1 using the
DOWN button, or the highest hardness setting
using the UP button.
1. SET PRESENT TIME OF DAY:
I«.f mml
Lim ira
t
f
1
FIR3I
«
]
f
t
R 1.0
ULt mu
i£m iim
t
T
»
ipnru
tC-UU
fmoi m
s
4
$
t
1
NOTE:
If AR- shows in the display, press the UP 0or
DOWN ©Jutton until AR31 shows. Then, press
the #1 SELECT button to set, and change to the
flashing PRESENT TIME display.
To check the model code, unplug the transformer
at the wall outlet and plug in again,
if other than
AR31 shows, see page 18 to reset.
SOUND “BEEPER”: A “beeper” sounds while
pressing buttons for timer set-up. One beep
signals a change in the face plate display.
Repeated beeps mean the timer will not accept a
change from the button you have pressed, telling
you to use another button. For example, while
setting the hardness (step 2), the beeper sounds
NOTE:
If the words* PRESENT TIME do not show
in the display, press the #1 SELECT button
(FIG. 1) until they do, or see the notes above.
■ Press the 0UP/DOWN ©buttons to set the
present time. Press UP to move the display
ahead; press DOWN to move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
If the present time is between
midnight and noon, be sure
AM shows.
NOTE:
Each press of the UP/DOWN
buttons changes the time by 1
minute. Holding the buttons in
changes the time 32 minutes
each second.
wr MML
«
r
t
$
4
1
9
f
HDQ.
mm nc
SAT 5KMU
UVB L£Va
#
7
«
s
4
3
2
/0%“
wfierr m