Sears 831.287724 - Manual (Page 8)

MAINTENANCE AND TROUBLE-SHOOTING
Inspect and tighten all parts of the CARDIO FIT PLUS regularly. Keep the monitor out of direct suniight or the
display may be damaged. The CARDIO FIT PLUS can be cleaned with a soft, damp cloth. Keep liquid away from
the monitor. When storing the CARDIO FIT PLUS, remove the batteries from the monitor.
HOWTO REPLACE THE BATTERIES
If the display of the Monitor (1) becomes dim, the two L1154
watch batteries should be replaced. Lift the Monitor off the
Frame (6). Disconnect the Sensor Wire (15) from the
Monitor. Remove the four screws from the back cover of the
Monitor and remove the back cover (see the inset drawing).
Push the two old batteries out of the battery dips, noting
which way each battery is turned. Insert two new batteries.
Reattach the back cover of the Monitor (1). Connect the
Sensor Wire (15) to the Monitor. Insert all excess wire into
the Frame (6). Press the Monitor onto the Frame.
HOW TO ADJUST THE MAGNET AND REED SWITCH
Tf the monitor displays incorrect feedback, the Magnet (27)
and the Reed Switch (15) should be checked. Pivot the Pedal
Frame (32) until the Magnet is aligned with the Reed Switch.
Slightly loosen the #8 x 3/4’ Screw (18) in the Reed Switch.
Slide the Reed Switdi slightly closer to the Magnet. Tighten
the
#8 X 3/4’ Screw. Exercise on the CARDIO FIT PLUS for a
moment. Repeat until the monRor displays correct feedback.
Make sure that the Magnet does not hit the Reed Switch.
HOW TO LUBRICATE THE CARDIO FIT PLUS
Every three months, a small amount of light multi-purpose oil
should be applied to the CARDIO FIT PLUS. Apply a few
drops of oil between the dome caps and the frame in the
locations shown at the right. Make sure to apply oil to both
sides of the CARDIO FIT PLUS.
8