Sears 175.867029 - Manual (Page 6)

OPERATION
TEST FOR SOLUTION SPRAY
See Figure 6
1 Hold Floor Nozzle above floor level.
2. Pull Solution Release Trigger on Angled Wand.
3. Obsen/e Floor Nozzle to make sure cleaning solution
is being sprayed evenly, fsee DETAIL "A"J
NOTE: If solution is not being sprayed evenly, refer to
Trouble Shooting Chart.
SPRAYS OF
SOLUTION
Rg.6
CLEANING THE CARPET
See Figures 7 & 8
Solution Dispensing Stroke;
1. Start at a comer (recommended).
2. Place Roor Nozzle so Suction Inlets are flush with
carpet.
3. While exerting light pressure down on Floor Nozzle,
depress Solution Release trigger and slowly pull
Poor Nozzle towards you.
NOTE; Do not overwet. If three or more cleaning strokes
are required, let dry and then repeat cleaning proc­
ess.
Solution Recovery Stroke:
1. Release Solution Release Trigger.
2. Lift Floor Nozzle off carpet.
3. Return Floor Nozzle to point where you dispensed
cleaning solution and pull across carpet, recovering
dirty solution.
SUCTION INLETS
Rg. 7
LIFT.
SET FORWARD.
PULL BACK ACROSS CARPET
Rg. 8