Sears KENMORE 385.128418 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 2. PREPARE YOUR MACHINE FOR SEWING
« Pick Up Your Bobbin Thread
thread guide.
6.
Puis
the thread to the left and slip
It through the thread guide.
7.
Thread then Is slipped into needle
bar thread guide.
8.
Thread needle from front to back.
NOTE; You may want to cut the
end of the thread with sharp
scissors for easier needle
threading.
and rotate handwheel toward you
one complete turn.
back of the presser toot, leaving 3
to 4 inches of thread clear.
If you cannot pick up bobbin thread by following steps given above, then check:
1.
Is needle threaded from front to back?
2.
Is thread tangled around needle?
3.
Are 3 to 4 inches of thread coming from the shuttle?
4.
Is thread from shuttle tangled?
5.
Is bobbin properly installed in the bobbin case?
6.
Is the machine threaded according to the instructions?
15