Sears KENMORE 661.62442 - Manual (Page 5)

INSTALLATION
YOU RflAY WANT TO CONVERT YOUR COOLER TO SIDE DISCHARGE (Figure 3)
CONVERTING COOLER TO SIDE AIR
DISCHARGE (FIG.4)
0 Remove both louvers and set them where they
will not fall See pg. 11^ "Taking Off Louver"
(D Remove four grille clips on side opposite
motor
@ Remove a reservoir by pushing the water cros­
sover tube from the grommet and lifting out the
reservoir.
® Remove the second reservoir as above
® Remove the screw that holds the wiring box.
0 Remove Ve inch diameter and % inch diameter
knockouts,
0 Remove two plastic plugs,
® Loosen screw holding pad motor receptacle
bracket, slide bracket up and detach from
cabinet flange. Repeat on other side
9 Turn cooler to side outlet position (Figure 5)
REASSEMBLY AS SIDE
OUTLET COOLER (Fig 5)
0 Move wiring box to new iocation.
0 Secure wiring box with screw removed at
disassembly
0 Install four louver clips removed at
disassembly.
0 Instali two recepìade brackets removed at
disassembly.
0 Install two plastic plugs removed at
disassembly
6. Assembly reservoirs, crossover tube and louv­
ers afterthe cooler is installed in location. Use
soap or detergent to lubricate crossover tube
before inserting into grommet DO NOT USE
OIL
ROUTE WIRES INSIDE OF PANEL
FIGURE 3
FIGURE S