Sears KENMORE 661.62442 - Manual (Page 13)

CARE or YOUR COOLER
PUTTING ON NiEW PAD (Pig. 21) SEARS REPLACEMENT PADS
THE PADS NEED NO PREWETTING
C£ Put the lower roller in pad
0 Fit the lower roller into the botton slots in the
frame
0 Push the top roller through the pad Fit the roll
end over the pad motor shaft drive block
0 Push the top roller end into the bearing.
® Turn the bearing arm to hold the roller
(6) TUCK THE PAD EDGES UNDER THE 2
GUIDES ON EACH SIDE.
0 Put the two small center rollers in place. Snap
the ends into the holders, (See lubrication
instructions below)
OILING (Fig.22)
Use SAE 20 Non-detergent motor oil once
per year.
1 Fill the two blower shaft bearing cups @
2
Put two or three drops in the two oii f)!l tubes on the
biower motor (§) (Motors without oi! fiit tubes
have lifetime lubrication)
3 Pul two or three drops in the end bearing on each pad
motor (g)
BLOWER BELT ADJUSTMENT (Fig. 23)
CAUTION: DO NOT ADJUST BELTTENSION
BY CHANGING THE DIAMETER OF THE
MOTOR PULLEY. ADJUST BELT TENSION
ONLY BY MOVING THE MOTOR BRACKET.
1 If you can easily move the belt over 1 inch, it
needs ad|ustment,
2 To adjust belt tension, loosen the three motor
mount bolts
3 Push the motor to tighten the belt until belt
moves about % inch with finger force.
4 Tighten the three motor mount bolts
MODELNUMBERSEARS PAD NUMBER
661.623920 42-6293
661.624420 42-6293
661.624530 42-6294
661.624630 42-6295
m.6g4670_________ 42-6295
13