Sears 831.287627 - Manual (Page 4)

1. Tap a MZ” Bushing (25) into each Side of the Frame (6)
as shown. .
Apply grease to the Pivot Rod (21). Align the holes in
the Pedal Frame (7) with the indicated tube on the
Frame (6). Tap the Pivot Rod through the Pedal Frame
and the Frame.
IMPORTANT NOTE: Before assembling the 1/2"
Dome Caps (29), make sure that you thoroughly
understand the assembly step(s) they are used In.
They can be assembled only once. If they must be
removed, you will need to order new Dome Caps.
Center the Pivot Rod (21) and tap a 1/2" Dome Cap
(29) onto each end of it.
Make sure that the Magnet (27) Is on the Pedal Frame
(7).
Apply
Grease
2. Make sure that there is a 1/2” Link Arm Bushing (19) in
the right Link Arm (4) (see the inset drawing). Slide the
Link Arm onto the indicated pin on the Pedal Frame
(7). Pivot the Pedal Frame and tap a 1/2" Dome Cap
(29) onto the pin.
Attach the left Link Arm (not shown) in the same
manner.
3. Slide a 1 1/4” x 1” Endcap (13) onto each end of the
Handlebar (2). The Endcaps must be turned so the
round ends are on top.
Slide the Handlebar (2) into the Pedal Frame (7). The
Handlebar must be turned so the sides bend toward
the Seat (not shown). Align the holes in the Handlebar
with the holes in the Pedal Frame. Attach one side of
the Handlebar with two #8 x 1/2" Screws (16). Attach
the other side of the Handlebar with two #8 x 1/2”
Screws.
Slide the 1 1/4” x 1” Endcaps (13) down over the Pedal
Frame (7).
L
'p
^)-4)