Sears 8EAIRS - Manual (Page 5)

How to Set the Door Alarm.
You don't hove to set the visual
alarm.
As long as either door is
open, the red DOOR OPEN
signal tight Flashes.
If the signal light on the
DOOR ALARM pad is glowing,
the beeper alarm is set. If it's not,
touch the pad to turn it on.
If either door is open for more than
30 seconds, a recurring beep sounds
The light goes out and the beeping stops when you dose
the door
There are times when you'll wont the Door Alarm
beeper turned off. When you're rearranging a lot of
food, for example. Just touch the pad. The light will go
out and the beeping will stop.
Deactivating the Door Alarm beeper does not turn the
red DOOR OPEN light off—it keeps flashing until the
door is closed
Why the Red Warm
Temperature Light Glows.
At first, it's probably because
your newly Installed refrigerator
hasn't completely cooled down
yet. Woit a few hours for it to cool,
and then the light will go out
From then on, the red light will glow whenever
temperatures inside get too high for proper food storage
if this hoppens, open the doors only when absolutely
necessary, and dose them as quickly os possible
As soon as inside temperatures return to normal, the light
goes out
If the WARM TEMP light reappears and stays on for
longer than 4 hours, call for service.
How the Electronic Alert
and Diagnostic System Works.
The word NORMAL is lighted
except when a failure has
been detected-
SYSTEM
CHECK
The SYSTEM CHECK-RESET
pod has two functions:
1. You can touch the SYSTEM
CHECK-RESET pad and get a
review of the electronic diagnostic
codes in order of their priority.
2. You can touch the SYSTEM CHECK-RESET pad to
erase three flashing codes immediately and two codes
after the condition that caused them to flash has been
corrected (see the next page),
(continued next page)