Sears 8EAIRS - Manual (Page 17)

5. Pull fhe drawer parhvay
oul. Reoch in, push the rear
of fhe glass up; at the same
time, push it back until it
clears front-corner retainers-
6. Tilt and remove the cover,
7. Pull the drawer forward,
lift the front to clear stops,
and pull the drawer out until
it hits the door Then lift the
drawer up until It is higher
than the drawer supports,
tilt it and take it out
8. If tape holds bottom
drawer cover to drawer
supports, remove the tape.
Pull drawer partway out
Reach in, push the reor of the glass up and, at the same
time, back, until it dears front-corner retainers
9. Tilt and remove the cover.
10. Tilt and remove the drawer.
After cleaning, replace drawers and covers in reverse
order Reinstall the gasket at the rear of the top drawer.
Fit the end of the plastic
drawer support info the slot
on the qasket, with the rubber
gasket flap facing you Make
sure the gasket snaps into
ploce.
Then replace the light panel
by hanging top of panel on
upper pins and pushing in
at bottom
Drain Opening in Freezer Comparimenl
When cleaning, remove
the freezer bin and flush
Q solution of baking soda
(one teaspoon) and two
cups of hot (not boiling)
water through the drain
line with the help of a
meat baster This will help
eliminate odor and reduce
the likelihood of a clogged drain line.
If drain becomes clogged, use a meat baster and baking-
sod a-and-water solution to force the dog through the
drain line
Behind Refrigerator
Take care moving your refrigerator away from the wall.
All types of floor coverings can be damaged, particularly
cushioned coverings and those with embossed surfaces
Pull the refrigerator straight out and return it to position by
pushing it straight in. Moving refrigerator in a side
direction may damage floor covering or refrigerotor
Condenser
The condenser is located
behind the base grille. For
most efficient operation,
remove the base grille (see
page 3) and sweep away or
vacuum up dust that is reodily accessible For best results,
use a brush specially designed for this purpose, it is
available at your Sears store or service center. This easy
cleaning operation should be done at least once a year
Light Bulb Replacement
Utiphig refrigerator before changing a light bulb.
Fresh Food Compartment—Upper Light
1. Pul! off temperature
control knobs
2, Pull the bottom of the
light shield down and
forward, then rotate the
top up and off
After replacing with
same size bulb, reinsta
light shield
Fresh Food Comportment—Lower Light
(on some models)
This light is located behind a shield at the rear of
the fresh food compartment
1, Grasp the top edge of the shield and lift it up
and forward to free its top edge
2. After replacing with same size bulb, hook the top
of the shield back in place
Freezer Compartment
1. Remove shelf just below
light panel (Shelf will be
easier to remove if it is
emptied first )
2. Pull plastic light panel toward you. (It will bend to free
tabs from grooves,I
3. After replacing with same size bulb, reinstall panel
and shelf.
Convenience Center
1. Remove top door bin and
raise Convenience Center
inner door.
2. Press sides of flexible light
panel to release locking tabs and allow the panel
to swing down,
3. After replacing with night-light bulb of same wattage,
place rear tab of light panel into door and rotate panel
up until tabs lock into slots above
17