Sears 8EAIRS - Manual (Page 4)

Electronic Alert & Diagnostic System
® ® ®
N O R M A L DOOR OPEN WARM TEMP oo
PF POWER
d£ DEFROST
Ff FREEZER
a ICEMAKER
SYSTEM
CHECK
RESET
WATER
I CRUSHED
iCE
Kenmore
(T) Red signal light flashes to tell you when either door is
open.
@ Signal light tells you that the Door Alarm beeper has
been set to sound offer either door has been open 30
seconds.
@ Red signal light tells you when freezer foodkeeping
temperature is above normal.
(i) Lighted word normal indicates that no
failure has beert detected by the diagnostic system.
(D Flashing diagnostic codes in the display
warn you when:
power has been interrupted,
defrost system has failed
frozen foods should be checked.
icemaker may not be operating properly
What these codes mean-and what to do when they
appear—is summarized on the inside of the freezer
comportment door and explained more thoroughly on
the following pages.
System Check pad puts a review of the electronic
diagnosis of four coded functions at your fingertip
and also allows you to erase codes from display
Electronic control allows you to select ice cubes,
crushed ice or chilled wafer and signal light confirms
your choice.
g OaTRMAHiW
ON/OFF
When your refrigerator is first plugged in...
Ail panel lights come on for five seconds, a beep sounds,
and lights go off except as follows;
• PF flashes in the dispioy. Touch SYSTEM CHECK-RESET
pod to erase it,
• Word NORMAL glows
• Red WARM TEMPERATURE light glows if freezer
compartment temperature is higher than normal. It goes
off when proper foodkeeping temperature is reached
■ Door alarm beeper is activated and fight on DOOR
ALARM pad glows
• CRUSHED ice selection tight glows,
• Red DOOR OPEN light flashes if either door is open,
goes out when doors ore shut.
• Night light in water-and-ice dispenser is off.