Sears 580.761652 - Manual (Page 5)

Cut the tie wraps on the high pressure hose and
connect high pressure hose to gun. Tighten by
hand. Piace assembled spray gun on holder.
Remove plastic cap and connect high pressure
hose to pump. Tighten by hand.
Screw nozzle to nozzle extension.
Connect nozzle extension to spray gun.
CHECKLIST
Before you operate your new high pressure washer,
to be sure you receive the best performance and sat­
isfaction from this quality product, please review the
following checklist;
• Ail assembly instructions have been completed.
» The high pressure hose connections to the spray
gun and to the pump are tight and secure.
While learning how to use your high pressure
washer, pay extra attention to the following important
items:
® Engine oil is at proper level
• Be sure gas tank is filled properly with clean,
fresh, unleaded gasoline.
• Become familiar with ail controls - their location
and functiori. Operate those controls before start­
ing the engine.
MtL
CAUTION: Any attempt to crank or
start the engine before it has been
properly serviced with the recommend­
ed oil may resuft in an engine failure.
See Page 8 for instructions on adding
oil and proper oil specifications.