To remove pressure washer from carton, Assembly – Sears 580.761652 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
The following parts are shipped loose with your pressure
washer:
• Main Unit — pressure washer with wheels, guide han
dle and turbo nozzle.
• High Pressure Hose
• Manual Bag (which includes the items listed below)
• Nozzle Cleaner Kit
• Accessories Adaptor
• Parts Box (which includes items listed below)
• Spray Gun
• Wand Extension
• Hi/Lo Adjustable Nozzle.
• Wire Form
• Motor Oil
Become familiar with each piece before assembling the
pressure washer. Check all contents against the illustra
tion on Page 6. If any parts are missing or damaged, call
the Pressure Washer Helpline at t-800-222-3136.
TO REMOVE PRESSURE WASHER FROM
CARTON
• Remove loose parts and parts box included with pres
sure washer. The high pressure hose is packed in the
bottom of the carton on the guide handle end.
Remove the hose.
• Slice two corners at guide handle end of carton from
top to bottom so the panel can be folded down flat,
then remove ali packing material.
• Raise guide handle, secure in place and roll the pres
sure washer out the open end of the carton.
Loosen knobs
to raise handle
CARTON CONTENTS
Tighten knobs
when handle is
straight.
Check carton for additional loose parts.
For the most part, your Craftsman High Pressure Washer
has been assembled at the factory. You must, however,
attach the wire form, assemble the spray gun, and attach
the high pressure hose to the pump and ^ray gun,
• Insert the wire support with the longer arm positioned
on the left. From this view the hook should resemble a
“J”.
HOW TO SET UP YOUR PRESSURE WASHER
Cut tfe wrap on chemical injection lube. Remove chemi
cal injection filter, thread chemical injection tube through
ttie wire form and reinsert fitter into tube.