Carrier 58SSB User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
17. Reassemble motor and blower by reversing steps 9
through 12. If motor has ground wire, be sure it is
reconnected. Be sure wheel is centered in blower
housing. Spin blower wheel to check clearance.
18. Reinstall blower assembly in furnace.
19. Reconnect power leads from interface circuit board.
Reinstall auxiliary junction box cover.
20. Reconnect thermostat leads to terminal block TB4
on interface circuit board.
21. Reconnect 15-conductor cables.
22. Reconnect electrical leads from furnace control to
numbered panel mount connector located on left
side of interface box.
23. Reinstall control box on bottom side of blower shelf.
24. Refer to 38EV,QV outdoor section installation in
structions and inspect for proper blower operation.