Homelite 1600383 - Manual (Page 5)

3. See Figure 3. Attach two vertical supports to rear of unit.
Holes are pre-starriped in tractor, frairie. Use two curved
head bolts, lockwashers, and nuts to fasten each vertical sup­
port to unit.
m
U
1
REAR GOVER
(OPEN)
Figure 3.
^^;iSe&9F.igure 4.- .^©'jEMschá^^^ is shipped as a flat
.plastic sheet. Roll it i%o a tube and hold in shape with
phillips-htead screws. InStaiFscrews from;inside with a flat
washer under head of screw. ; Place another fiat Washer bn
outside^of -tube followed.by a.lockwasher arid nut: install
discharge tube-on end of;, chapter as shown in Figure 1.
SCREWS
GRASSBAG '
MESH PANEL
5. See Figure 3. The grass bag tubular frame assembly, on
which the grass bag hangs, has two tubular supports welded
to its front side in position to fit over vertical supports. To
install bag on this frame, bag zipper must be completely
unzipped, allowing grass bag plastic top panel to unfold.
6. On front side of grass bag, opposite mesh panel, there
are two holes in plastic top panel. Insert two tubular sup­
ports welded to grass bag frame down through these two
holes with cloth portion of bag toward inside of frame and
with plastic top panel on outside of frame.
7. Roll plastic top panel up and over frame tube and bring
two halves of zipper together on inside of frame. Connect
ends of zipper together at point "A". See Figure 4. Work
zipper handle counter-clockwise completely around frame.
8. See Figure 3. Install frame and bag assémbly in vertical
supports. Insert rear end of discharge tube in hole at left
front corner of grass bag. See Figure 4.
9. See Figure 5. To install grass bag cover, position it above
bag, align cutout on front side with discharge tube, and push
down firmly to snap spring clips over outside of bag frame,
and top panel.
WARNING
Before emptying grass bag, always stop tractor, dis­
engage power take-off drive to mower, place trans­
mission in neutral, apply parking brake, and stop
engine.
Figure 4.