Homelite 1600383 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TRACTOR DRIVE MECHANISM
IDLE
BRACKET
SPRING
CAPSCREW
FLAT
WASHER
STEP 1. Place direction control
lever in "Neutral" position.
STEP 2. Open tractor rear cover.
STEP 3. Adjust nut until spring
is compressed 1-1/8 inches.
STEP 4. Turn elastic nut
snug against frame.
STEP 5. Close cover, place
tractor in upright position.
STEPS. Place reference mark.'
STEP 10. Place reference mark and
check indicated dimension.
STEP 7. Rotate shaft awgy from
you as far as possible.
STEP 9. Rotate shaft toward
you as far as possible.
STEP 12. Adjust shaft assembly by
raising or lowering to obtain indicated
dimension (Step 10)._______________
STEP 11. If indicated dimension not
obtained, loosen four capscrews.
STEP 13. Secure capscrews to 15
foot-pounds torque.
10