beautypg.com

Specifications subject to change without notice – Homelite 1600383 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

CAUTION

2. Blade may be unbalanced or damaged.

IF VIBRATION OCCURS, stop tractor immediately.

3. Drive pulley may be bent or misaligned,

disengage mower drive clutch, stop engine and check
the following.

Repair any damage and correct out of balance condition

before starting mower.

1. Arbor shaft or tube (or both) may be bent.

For instructions on removal and installation of mower

see MAINTENANCE section of this manual.

engine

specifications

Make ................. ...................... • ■ ■ ................................. Briggs and Stratton
Model No.................................. .............................................190707

Type ....................................................... .. ...... ....................0861-01

H.P. ..................... ■ ■ . ■ ........................ .......................... .8 @ 3600 RPM (Engine Mfg. Rating)
Displacement ......... ................................ ........................ . .19.44 cu. in.

GOVERNOR

Type .................................................................................. . .Adjustable, mechanical

Working Range ..................................................................... 1800 - 3400 RPM for best mowing performance

LUBRICATION

Type ...................................................................................... Gear Impeller System

Capacity ......................................................... ......................2-3/4 Pints extended oil fill for ease of servicing

STARTING

.................................................................................. .Factory installed 12V electric with 3 amp alternator and

solid state rectifier.

FUEL CAPACITY .......................................................................3 Quart

TRACTION DRIVE TYPE .......................................................... Hand operated forward, neutral, reverse V-belt shuttle drive

to a two speed, all gear, fully enclosed transmission and

differential.

Speeds @ 3400 RPM -Low .................................................. Forward - 2.52 MPH, Reverse - 2.52 MPH

-High ................................................ Forward - 3.92 MPH, Reverse - 3.92 MPH

CLUTCH AND BRAKE ...............................................................Foot operated

clutch-brake combination over-rides

shuttle drive for emergency stops.

FRAME TYPE

Front and Rear - U -Channel .......... .............................. .. . IHeavy gauge steel

DIMENSIONS

Width .............................................;........................• ■ ■ ■

40-1/4" with mower and safety shield in place

Length ................................................................. .. .57-3/4"

Wheel Base ...... ................................................................. .44-3/8"

Height ....................................................................................Top of steering wheel 36-1/4"

Tread Width .............................................................. .Front - 28", Rear - 28"

STEERING

Ratio ............................................................ .. .3.81:1

Turning Radius (Inside Rear Tire) ......................... .22"

TIRE SIZE

Front ,...............................................; . ....................... .. .410

X

3.50

X

4 Turf Tread - 24 pounds pressure

Rear ...................................................................................... 16

X

6.50 x 8 Turf Tread - 10 pounds pressure

ROTARY MOWER

Width of Cut ........................................................................ .30"

Mounting ............................................................................... Full floating-attached to and tilts with front axle

Rear Support .........................................................................Three rollers, two adjustable for height and one fixed

Height Adjustment .................................................................Stepless screw, range 1-1/2" to 3-1/2"

Distance between mower blade and deck ...........................2-1/2" to 4-1/8" at chute

WEIGHT WITH MOWER

Weight Net .............................................................................346 pounds

Shipping Weight .................................................................... 406 pounds

ATTACHMENTS

Available as extra Equipment ................................................Hub Caps

SPECIFICATIONS SUBJECT TO CHANGE

WITHOUT NOTICE

17

This manual is related to the following products: