Homelite 8H.P - Manual (Page 3)

ACCESSORIES
TINE EXTENSION SET (Mfg. No. 1600406)
See Figure 1. The extension set consists of a left and right
tine assemblies with mounting pins and cotter pins. Mount
long hub of extension over outside end of standard tine
assembly and secure assemblies together with pin and cotter
pin. Be sure sharpened edges of tines on top face forward.
The extension set increases effective tilling width to 35
inches.
FURROW OPENER, 8-INCH (Mfg. No. 1600373)
See Figure 2. The furrow opener is intended for digging
furrows for crops which must be planted in rows. To install,
proceed as follows:
1. Remove the depth bar, turn it upside down and bolt it
to the tool holder (A) with the carriage bolts, washers and
nuts provided.
2. Remove the stop plate from between the frame supports
and install the extension support (B) with the old hardware.
3. Position the depth bar in the extension support and re­
install the depth bar clamp using the pin and spring clip
provided. Bolt the furrow opener to the tool holder as
shown.
SPECIAL WORM GEAR OIL
CAUTION
Damage to the worm gear drive which results from
use of any lubricant other than that specified, will
invalidate the warranty. (See back cover for special
Worm Gear Oil Part Number).
ASSEMBLING
1. Remove all components of tiller from box and place them
in a clean, level area. Inspect each part for damage.
2. Remove belt cover.
3. See Figure 3. Assemble left and right handles to frame as
shown. Note locations of flat washers.
4. Connect throttle cable as follows:
a. See Figure 8. Move throttle control handle to FAST
position. Be sure throttle cable wire is securely attached
to throttle arm under control panel. From the throttle