Homelite LM-09904-47 - Manual (Page 4)

7. Mount one end of the 7” hose to the hose flange using
one of the larger hose clamps and one 1/4-20 x 2” ma­
chine screw, lockwasher and hex nut (Figure 4).
8. Slide the hose flange into the slots in the blower hous­
ing (Figure 4).
9. Install the hose extension in the other end of the 7" hose.
Secure with the other large hose clamp and one 1/4-20
X 2" machine screw, lockwasher and hex nut (Figure 5).
NOTE: 1973 mowers 42” and 48" are equipped with a de­
flector shield. To mount the adapter on these
mowers, raise the mower to full height and remove
the two carriage bolts holding the deflector in the
position. Lift the deflector to a vertical position
and install the adapter following assembly instruc­
tions No. 10 and No. 11. After this is done, fold the
deflector shield down so that it rests on top of the
adapter housing (Figure 6).
10. Raise the mower to full height. Install the two 3/8-16
X 1" carriage bolts through the holes in the mower deck
from underneath. Secure with two 3/8” lock washers
and two 3/8-16 hex nuts (Figure 6).
11. Insert the pin on the rear edge of the vacuum collector
adapter through the hole in the rear edge of the mower
deck. Locate the two large holes in the top of the adapter
over the carriage bolts in the mower deck. Secure with
the two nut assemblies (Figure 6).
12. Slide thehose extension over theadapter discharge pipe
(Figure 5).
Mounting the High Capacity and Low Profile Trailer
Frames and Covers
There are two covers available for the HOMELITE dump
cart for use with the HOMELITE vacuum collector system.
These are the low profile trailer frame and cover and the
high capacity trailer frame and cover. Both covers come
preassembled to their frames.
The low profile trailer frame and cover is assembled as
follows:
o
IJ/