Homelite LM-09904-47 - Manual (Page 3)

HOMELITE PT.O. Driven Vacuum Collector
TheHOMELITE PTO Driven Vacuum Collector requires two
accessories for its operation. These are a) a HOMELITE
dump cart and b) either one of two available cart covers .
Not required, but available as an option, is a roving nozzle
for the vacuum collector. The assembly instructions and
parts lists for the PTO Driven Vacuum Collector, the two
cart covers and the roving nozzle are contained in this book,
The instructions and parts list for the dump cart will be
found packaged with the car .
Assembly
Mounting the Vacuum Collector
1. Install the drive pulley on the tractor PTO shaft using
a 3/16 X 3/16 X 1" key. Secure the pulley with the set
screw provided. Install the three belt stops on the
tractor frame. The 7/16-14 x 1-1/4" capscrew pro­
vided for the upper belt stop, replaces the original cap
screw on the tractor (Figure 1).
2. Install the lift shaft on the rear of the tractor usingthe
two set collars. Secure the set collars with the two
5/16-18 set screws provided (Figure 2).
3. Place the hooks on the upper arms of the support as­
sembly over the lift shaft. Align the holes in the lower
arm of thesupportassembly with the holes in the tractor
frame. Secure with two pins and two quick pins.
(Figure 2)
4. Move the PTO lever forward to the disengaged position.
Install thedrive belt over the drive pulley. Align the
drive pulley with the pulleys in the belt drive cover.
Check to insure that the belt is properly seated in the
four pulleys. Adjust the belt stops as shown (Figure 3).
5. Attach the deflector to the blower housing with two 3/8"
self tapping screws (Figure 4).
6. Place the 6" diameter hose over the deflector and blower
housing and secure with the smaller of the hose clamps
using one 1/4-20 X 2" machine screw, lockwasher and
hex nut (Fieure 41.