Philips AZ1010-17 - Manual (Page 4)

BASIC FimCTTONS
I dw i«t on Rod off
Set the POWER control to the desired sound source:
CD, TAPE, or BAND (for radio).
The set is switched off when the POWER control is set to
OFF/TAPE and the keys of the tape deck are released.
Note: If you use batteries, switch the set off after use. This will
avoid unnecessary power consumption.
Adjust the volume using the VOLUME control.
Increase and decrease the bass level by pressing D6B.
The bass level can also be emphasized if you place the set against
a wall or shelf. Do not cover any vents; leave sufficient room
around the unit for ventilation.
-irnjTj--
>! I I y
lit
Badto-tnwfl to radio statioiia
1 Set the POWER control to FM or AM to select the desired
wave band.
2 Tune to the desired radio station by using the TUNING wheel.
Improving RADIO roception
For FM stations, pull out the telescopic antenna. To improve the
signal, incline and turn the antenna. Reduce its length if the signal
is too strong (very close to a transmitter).
For AM stations, direct the internal antenna by turning the whole
set. The telescopic antenna is not needed.
m^m
1 Set the POWER control to CO.
2 Press A OPEN to open the CD compartment.
3 Insert an audio CD (printed side up) and close the CD
compartment,
-* The CD player starts and scans the contents list of the CD.
Then, the CD player stops. Display indication: the total
number of tracks.
4 Press the >ll button to start CD play.
^ Display indication: the current track number
5 Press the O button to stop CD play.
— Display indication: the total number of tracks.
You can pause CD play by pressing NO. Continue CO play by
pressing the button again.
Display indication: the current track number (flashing).
Now: CD play will also stop if:
- you open the CD compartment.
- the end of the CD is reached, or
- you move the POWER control.
If you make a mistake when operating the CD player, or if the
CD player cannot read the CO, the display shows f
or no. (See
"TROUBLESHOOTING”.)
If you press NB and there is no CD inserted, the display
shows rto.
All reduf^nt packing material has been omitted. We have done our utmost to make the
packaging easily s^raWe Into three mono materials: cardboard (box), polystyrene foam (buffer)
and polyethylene (bags, protective foam ^reet).
Your set amists of mwriafs whid) can be recycled if disassembled by a specialized company.
Please observe the local regulations r^arding the disposal of packir^ iraterials, r^ad batteries
andoldequipmmt.