Philips AZ1060 - Manual (Page 17)

DIGITAL TUNER
TUNING TO RADIO STATIONS
7. Select RADIO source. ^
The function indication lights up. Cu is displayed briefly
and then the radio station frequency is shown.
2. Press BAND once or more to select your waveband.
3. Press SEARCH m or and release when the frequency in
the display starts running.
-'The radio automatically tunes to a station of sufficient
reception. Display shows Srch during automatic tuning.
If a FM station is received in stereo, stereo is shown.
4. Repeat step 3if necessary until you find the desired station.
• To tune to a weak station, press SEARCH or briefly and
repeatedly until you have found optimal reception.
To improve radio reception
- For FM, pull out the telescopic antenna. Incline and turn the
antenna. Reduce its length if the signal is too strong (very
close to a transmitter).
- For AM, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by
turning the whole set.
5. To switch off, adjust the POWER slider to TAPE/ off position
with the keys on the tape deck released.
-> The function indicator goes out.
¡2
'ei
Programming radio stations
You can store up to a total of 30 radio stations in the memory.
7. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
- Display: program flashes.
3. Press PRESET T or A once or more to allocate a number from
1 to 30 to this station.
4. Press PROG again to confirm the setting.
- Display: program disappears, the preset number and the
frequency of the preset station are shown.
5. Repeat the above four steps to store other stations.
- You can erase a preset station by storing another frequency in
its place.
Tuning to preset stations
Press PRESET T or A until the desired preset station is
displayed.
I
I n LI n n
I I LI I.UU
MHiuia FM
o-
11