Cabletron Systems 7H02-06 - Manual (Page 23)

Installation
3-5
3.3.2 Removing the 7H02-06 Module from a 7C03 MMAC
SmartSwitch
To remove the 7H02-06 Module from a 7C03 MMAC SmartSwitch,
follow the listed steps and refer to Figure 3-4.
Note: Before removing the 7H02-06 Module, attach the wrist strap
included with the module (instructions are printed on the packet).
1. Use a slotted screwdriver to loosen the two screws that secure
the module to the chassis.
2. Locate the two ejector tabs on the module (to the right of the
screws on the top and bottom of the module).
3. Simultaneously press down on the bottom ejector tab and press
up on the top ejector tab until the module ejects from the
backplane.
4. Grasp both ejector tabs and carefully slide the module out of
the chassis.
Figure 3-4. Removing the 7H02-06 Module from a 7C03 MMAC SmartSwitch
Screws
Ejector
Tabs