Ram Trucks 2015 ProMaster - User Guide - Manual (Page 72)

MESSAGE DESCRIPTION
Press Brake Pedal And
Try Again
This message appears accompanied, in some
cases, by a warning buzzer, if you attempt to
change gear with the vehicle parked without
pressing the brake pedal.
To shift the transmission (with key on/engine off),
press and hold the brake pedal, move the shift
lever to NEUTRAL (N), then move the shift lever
to the desired position.
Shift To Neutral This message appears, together with a warning
buzzer, when the shift lever must be moved to
the NEUTRAL (N) position.
When the shift lever is moved to NEUTRAL (N) the
message on the display should go off.
Contact your authorized dealer if the message
continues to appear.
Press Brake Pedal This message is shown in the display together with
an acoustic signal, when the brake pedal is not
pressed during a starting attempt.
Press Brake Shift to N key to
start
This message appears, after the door opening, to
remind to Press the Brake pedal and shift the lever
in N to permit the cranking.
Parking The Vehicle
To park safely, it is essential to engage MANUAL (1st) gear, DRIVE (D) or REVERSE
(R) gear while your foot is on the brake pedal. Once MANUAL (1st) gear, DRIVE (D)
or REVERSE (R) gear is displayed in the EVIC, turn the engine off and engage the
parking brake. It is essential to wait until the gear engaged appears in the display
before turning the engine off and releasing the brake pedal. Always remember to set
your parking brake.
NOTE:
NEVER leave your vehicle with the gearbox in NEUTRAL (N) and always remember to
fully apply your parking brake. Always remember to set the parking brake when the
“Set Park Brake” message is displayed.
WARNING!
You or others could be injured if you leave the vehicle unattended without fully
applying the parking brake. The parking brake should always be applied when the
driver is not in the vehicle, especially on an incline.
D I E S E L
70