Ram Trucks 2015 ProMaster - User Guide - Manual (Page 70)

To drive, start the engine, then move the shift lever from NEUTRAL (N) to the DRIVE
(D) position for automatic mode, the MANUAL (M) position for manual mode or the
REVERSE (R) position.
NOTE:
Only shift into DRIVE (D) or REVERSE
(R) when the accelerator pedal is re-
leased and the vehicle is stopped. Be
sure to keep your foot on the brake pedal
when shifting between these gears.
Instrument Cluster Messages
Messages will be displayed in the instrument cluster to alert the driver when certain
unusual conditions occur. These messages are described below:
MESSAGE DESCRIPTION
Transmission/Gearbox Fault
(Red)
When the ignition key is turned to ON/RUN/MAR,
the Transmission Fault Indicator light turns on and
should go off after a few seconds.
The Transmission Fault Indicator illuminates either
steady or blinking (together with this message and
a buzzer) to indicate a transmission fault.
Contact your authorized dealer if the message con-
tinues to appear.
Reduce Gear Changes This message indicates that the driver is operating
the transmission incorrectly.
Incorrect use (by the driver) could automatically
activate a procedure for protecting the system.
Contact you authorized dealer if the message con-
tinues to appear.
Manual Mode Not Available MANUAL (M) mode is not available, due to a fault
or other condition. Use the DRIVE (D) position to
operate the vehicle.
Contact your authorized dealer if the message con-
tinues to appear.
Shift Lever
D I E S E L
68