Küat TRIO - Manual (Page 2)

ADJUST STRAP CRADLE TO BE
CENTERED UNDER REAR TIRE
BOTH SIDES OF BIKE STRAP CAN
BE ADJUSTED TO PREVENT
CONTACT WITH VEHICLE ROOF
2
1
SLIDE STRAP THROUGH REAR
SLIDING CRADLE ON RACK. STRAP
CAN BE INSERTED FROM EITHER SIDE.
REAR STRAP INSTALL & USE
Hand thread all security barrel nuts prior to using 5 sided security wrench.
Alternate tightening of each barrel nut until tight. WARNING: Excessive
overtightening may dent vehicle cross bar.
FRONT CROSS BAR INSTALL
REAR VEHICLE RACK MOUNTING
REAR CROSS BAR INSTALL
Slide rear strap bolts into“T” slot on bottom of Rüfee rack. Place
cross bar strap over strap bolts and thread on knobs by hand.
FRONT VEHICLE RACK MOUNTING
ROOF BAR MOUNTING RANGE
500mm TO 1275mm
19-5/8" TO 50-3/16"
MOUNTS TO VEHICLE CROSS BARS AS THIN AS 15mm or 0.6”
MOUNTS TO FACTORY
AND AFTERMARKET
ROOF CROSS BARS
ROUND
SQUARE
OVAL
AERO
MAXIMUM CROSS BAR WIDTH
90mm or 3.5”
MAXIMUM CROSS BAR THICKNESS
43mm or 1.7”
MOUNTING RANGE
Use skewer tube wrench to remove 9mm
skewer. Turn left to loosen. When loose,
pull out 9mm skewer and insert 20mm or 15mm
axel to noted insert line. Turn skewer tube wrench to
SKEWER/AXLE INSTALL
20mm & 15mm AXLE MOUNT
SKEWER TUBE WRENCH
ROOF RACK
BURLAP BAG
KEY (2)
BOTTLE OPENER
SKEWER TUBE WRENCH
U-BOLT WRENCH 15mm SKEWER TUBE
20mm SKEWER TUBE
REAR STRAP
U-BOLT (2)
SECURITY NUT (4)
REAR STRAP BOLT (2)
REAR STRAP KNOB (2)
9mm SKEWER
CROSS BAR STRAP
PRE-INSTALLED
INVENTORY
The 9mm skewer can be installed
from either side of the vehicle you
are mounting the rack.