Engine pre alarms & alarms – Winco GM100 User Manual

Page 8

Text mode
Original mode

6. Engine Pre Alarms & Alarms

The controller monitors engine oil pressure, engine temperature and engine
speed directly using sensors. If measured parameters become out of
tolerance, the controller will begin to prealarm the specific condition. If the
parameter exceeds the fault values, the controller will open the run signal
causing the engine to shutdown.

6.1 Engine Pre Alarms

6.1.1 In the case of an engine pre alarm, the yellow LED will illuminate.

6.1.2 The engine will continue to run.

6.1.3 If the out of tolerance value is one of the full time display items, the

number will flash every second on the display. (Defaults shown
below)

•

Low Fuel Level < 20%