Winco GM100 - Manual (Page 13)

10. Control AC / DC Adjustments
AC Volts
Adjust
AC Amps
Adjust
485 Port
Battery
Adjust
AC Circuit
Board
CT Input AC Voltage
Input
10.1 AC Voltage Adjustment – Using the pcb mounted calibration pots, the
displayed voltage can be adjusted to match
the output of the generator.
10.2 AC Amps Adjustment – Using the pcb mounted calibration pots, the
displayed current can be adjusted to match the
output of the generator. The adjustment is
limited to the pre-programmed range of the
current transformer inputs. The size of CT’s to
be used must be known at the time of ordering.
12