Winco 2-Wire Conversion Instructions ULPSS8B2W/E - Manual

INSTALLATION INSTRUCTIONS FOR 2-WIRE
AUTO START CONTROL CONVERSION
The following instructions are provided to convert the ULPSS8B4W/E
from a special 4-wire start system to a standard 2-wire Auto Start System.
Items required:
WINCO Conversion Kit # 16448-007 Auto Start
T25 Torx Screwdriver
7/16” End Wrench or Socket & Driver
Wire Side-Cutter
Wire Crimper
PROCEDURE
1. Remove right side panel, rear door, left side door and roof.
2. Move the left hand toggle switch “A” to the “STOP” position.
3. Locate the two wires connected to the left side of the engine. Remove the wires
from the bolt by taking the nut off. Cut the terminal connector off each wire. Crimp a
wire cap to each wire individually. Replace the nut. See picture on page 2..