beautypg.com

Setup & installation – WaterChef C7000 User Manual

Page 6

background image

www.waterchef.com

I

4

SETUP & INSTALLATION

10. Determine which side of the sink

you want your System:
To position System to the LEFT side

of your sink: Unthread Lid Assembly

from Filter Housing, then orient the Lid

Assembly to Filter Housing as shown.

(fig. F, Step 1)

Once positioned, thread

Lid Assembly clockwise onto the Filter

Housing until tightened.

(fig. F, Step 2)

To position System to the RIGHT side

of your sink: Unthread Lid Assembly

from Filter Housing, then orient the Lid

Assembly to Filter Housing as shown.

(fig. G, Step 1)

Once positioned, thread

Lid Assembly clockwise onto the Filter

Housing until tightened.

(fig. G, Step 2)

11. Press the elbow fitting on Diverter Valve Assembly

into the Filter Base.

(fig. H)

12. Insert Battery Shuttle (with included Battery) into Lid

Assembly.

(fig. I)

The Intelligent Monitor

will flash

GREEN, YELLOW and RED five times. This resets

the rated capacity counter to zero gallons. Do NOT

remove Battery Shuttle until it is time to replace

the Filter Cartridge. Removing Battery Shuttle

prematurely may result in a loss of data.
13. With System placed on the counter and positioned

so that water will flow into kitchen sink, turn the cold

water faucet “ON” and pull Diverter Pin.

(fig. J)

Water

will begin to fill the Filter Housing. Once water begins

to flow from the System, the Intelligent Monitor

will

begin flashing GREEN to indicate peak operational

performance. Check to see that all hose, lid and

housing connections are tight and do not leak.
14. Allow System to flush into sink for 15 minutes.

This will remove any fine, black carbon particles left

over from the manufacturing process, expel trapped

air and condition the Filter Cartridge for normal use.

(This water may be used to water plants.)

spout

facing

into sink

spout

facing

into sink

STEP 1

STEP 1

STEP 2

STEP 2

LEFT Placement

RIGHT Placement

line up

FRONT

of Lid

Assembly

with hose

outlet

line up

BACK

of Lid

Assembly

with hose

outlet

F

G

H

J

Repeat flushing procedure each time a new Cartridge is installed.

IMPORTANT

Congratulations! Your new WaterChef

®

Filtration System is ready!