Water Factory Systems FM1500 Faucet - Manual (Page 7)

1. Close the feed water valve and lift up the faucet handle.
Wait approximately 10 seconds for the water pressure
to depressurize. Return faucet handle to the off
position.
2. Twist the filter cartridge 1/4 turn counterclockwise (as
viewed from the bottom) so that the ears on the
cartridge are able to disengage from the head. Firmly
pull the cartridge downward to remove it from the
head.
3. Remove the new filter cartridge from its sanitary sealed
wrapper. (Double check to see that it is the correct
replacement filter cartridge by comparing the labels.)
4. Using either tap water, food grade silicon lubricant or
glycerine, lubricate the O-ring seals to make cartridge
insertion easier. Do not use petroleum jelly.
5. Line up the cartridge ears, insert the cartridge and push
it up into the head until it is fully seated. Twist the
cartridge 1/4 turn clockwise to lock it into place.
6. Open the feed water valve and carefully check for
leaks.
7. Lift up on faucet handle to purge air and carbon fines
from the new filter cartridge. Flush 3 gallons through
system before use (approximately 6 min).
NOTE: It is normal to have small air bubbles present in the
product water for 1-2 days after installation and filter
changes. This may result in cloudy filtered water.
It is recommended that car tridg es be replaced every 6-12 months, depending on local water conditions and use.
7
Replacement Cartridge Change Instructions
FM DWS 1500
Turn Clockwise To
Shut Off
Turn Counterclockwise
To Turn On